|
Link
to Board Layout(RCI 5054DX)
Note: set the deviation level of the
CTCSS output to 750hz
*If reverse phase burst is desired, perform the following
steps:
A. Locate J10 on the main pcb.
B. Cut the purple wire labeled PT, insert the PTT
input and PTT output on the TE-32 in series with the
purple wire (the SS-64 will now control the transmit
PTT line).
C. + Voltage: connect to 8V O/P eyelet (do not connect
to TX+).
D. On SS-64: install jumpers on JP1 & JP2.
Note:
For optional hookups and programming information for
TE-32, please refer to manufacturer's instructions
sheet. |
